Camshaft Position Sensor XGZR6191

Using small-volume, low-cost samarium cobalt magnets as the magnetic field source of the product; Using electromagnetic pure iron with low coercivity and high permeability to improves the utilization rate of permanent magnet magnetic field and response time; The glazed wire resistant to high pulse voltage is used as the source of the product signal.

Finally, the coils, permanent magnets and magnetically conductive pure iron are assembled and injection-molded. The process is simple, the product injection molding consistency is good, the size is small, and the cost is low.



The sensor is mainly aimed at the commercial vehicle and passenger vehicle markets, and are applied to the engine power system, measuring the speed and position of the engine camshaft, crankshaft, and ABS wheel speed detection in the braking system.



Camshaft position sensor XGZR6191 is a mature and reliable passive speed sensor product launched by CFSensor for the automotive market. The product has no circuit module and is mainly composed of coils, permanent magnets, magnetically conductive pure iron, terminals, flange gaskets, sealing rings plus outsourced injection molding and other components. The camshaft position sensor have simple structure and prefect consistency injection.



camshaft position sensor xgzr6191 dimension


ORDER GUIDE (100kPa=0.1MPa=1bar≈14.5PSI)

camshaft position sensor xgzr6191 order guide


Datasheet: XGZR6191 Rotational Speed Sensor-V1.0.PDF



Using these sensors products may malfunction due to external interference and surges, therefore, please confirm the performance and quality in actual use. Just in case, please make a safety design on the device (fuse, circuit breaker, such as the installation of protection circuits, multiple devices, etc.), so it would not harm life, body, property, etc even a malfunction occurs. To prevent injuries and accidents, please be sure to observe the following items:

  • The driving current and voltage should be used below the rated value.
  • Please follow the terminal connection diagram for wiring. Especially for the reverse connection of the power supply, it will cause an accident due to circuit damage such as heat, smoke, fire, etc.
  • In order to ensure safety, especially for important uses, please be sure to consider double safety circuit configuration.
  • Do not apply pressure above the maximum applied pressure. In addition, please be careful not to mix foreign matter into the pressure medium. Otherwise, the sensor will be discarded, or the media will blew out and cause an accident.
  • Be careful when fixing the product and connecting the pressure inlet. Otherwise, accidents may occur due to sensor scattering and the blowing out of the media.
  • If the sensor come with sharp PIN, please be careful not to hurt your body when using it.


The information in this sheet has been carefully reviewed and is believed to be accurate; however, no responsibility is assumed for inaccuracies. Furthermore, this information does not convey to the purchaser of such devices any license under the patent rights to the manufacturer. CFSensor reserves the right to make changes without further notice to any product herein.

CFSensor makes no warranty, representation or guarantee regarding the suitability of its product for any particular purpose, nor does CFSensor assume any liability arising out of the application or use of any product or circuit and specifically disclaims any and all liability, including without limitation consequential or incidental damages. Typical parameters can and do vary in different applications. All operating parameters must be validated for each customer application by customer’s technical experts. CFSensor does not convey any license under its patent rights nor the rights of others.

Let's Work On Your Sensor Project!

Let CFSensor team help you explore all of the possibilities to build the perfect sensor!

CFSensor R&D Team
Start typing to see products you are looking for.

Contact Us